Page 1 of 1

What happened here?

PostPosted: Sat Nov 10, 2012 11:20 am
by tonnes
I've been evaluating the program...so far so good until I ran into this. 9 exposures, 1ev apart. What happened?

Re: What happened here?

PostPosted: Sat Nov 10, 2012 12:57 pm
by Sebastian Nibisz
You can show the source exposures?

Re: What happened here?

PostPosted: Sat Nov 10, 2012 7:30 pm
by tonnes
Using DNGs, converted in DXO from CR2's from a 5DmkII. Deghosting & noise reduction selected.

The error does not happen on the original CR2's - only the DNG's. The DNG's are not corrupted - they open properly in PS & Oloneo.

brackets.jpg
brackets.jpg (167.03 KiB) Viewed 10583 times

Re: What happened here?

PostPosted: Thu Nov 15, 2012 8:50 pm
by Sebastian Nibisz
This is very strange.
You try to load the fifth exposure into SNS-HDR. Do you see this area?

Re: What happened here?

PostPosted: Thu Nov 15, 2012 9:06 pm
by tonnes
I am sending all 9 DNG's to you. Look for an email from WeTransfer.com.

Re: What happened here?

PostPosted: Thu Nov 15, 2012 9:45 pm
by Sebastian Nibisz
Thanks, I downloaded. I will check this.

Re: What happened here?

PostPosted: Thu Nov 15, 2012 10:09 pm
by Sebastian Nibisz
DxO created bad image. Overexposed area is not white. SNS-HDR does not know that this area is overexposed.

Image

You disable the removal ghosts function.

Re: What happened here?

PostPosted: Thu Nov 15, 2012 11:02 pm
by vinz
perhaps this is because the new DXO smart lighting or other light recover corrections were enabled, i noticed sometimes these option create false overexposition ... imo, when exporting from dxo to dng for sns, it''s better to disable every light and color corrections.

Re: What happened here?

PostPosted: Fri Nov 16, 2012 1:56 am
by tonnes
You're right! I reprocessed the CR2's without any of the DXO lighting corrections and everything worked as expected. Thank you!