Page 1 of 1

Mask Amount sliders

PostPosted: Tue Nov 01, 2011 7:24 pm
by den
To further enhance the mask usefulness in addition to Invert and Copy [previously suggested]...

...would it be possible to use Black/White Amount sliders rather than perhaps the Invert switch where Mask white at 100% is the image area to be changed and Mask black at 0% is the protected image area?...

By reversing Mask white to 0% and Mask black to 100%, you have an Invert... ...but in addition, you have Amount control for partial changes in either the white or black or both masked image areas...

White/Black could be any color... just used here to represent protected and unprotected image areas for change.

Re: Mask Amount sliders

PostPosted: Tue Nov 01, 2011 8:27 pm
by Sebastian Nibisz
You want to have a possibility to regulate the mask opacity?

Re: Mask Amount sliders

PostPosted: Tue Nov 01, 2011 10:09 pm
by den
Yes... ...but with opacity control for both the protected and un-protected image areas...

mask_opacity_800px.jpg
mask_opacity_800px.jpg (83.73 KiB) Viewed 5532 times


This is not a deal breaker... just familiar with this masking feature in another editor.

SNS-HDR's image blending/auto-preset tone mapping is so much a plus "as is"...